Monitoring the array in reset-read-read modeSWIR 3 Show NOTCam R-R-R database Gain for each quadrantPlotted line correspond to mean value X-axis tics are plotted every 10th day
Read out noise for each quadrantPlotted line correspond to mean value X-axis tics are plotted every 10th day
Normalized count rate for each quadrant from newest dataIn the 3 first points there may be a significant shutter effect. Normalization is done using 4th, 5th and 6th points. Light level during the test may not be constant enough to give very reliable result.
Reset levels for each quadrantPlotted green line corresponds to mean value Errorbars correspond to standard deviation Blue (yellow) lines show max (min) values X-axis tics are plotted every 10th day
Amount of zero pixels (%)X-axis tics are plotted every 10th day
Zero pixel map shows where zero pixels are in latest data. 
Full resolution zero pixel map Amount of hot pixels (%)Fraction of pixels that deviate more than 8-sigma from mean value. Used exposure time was 42 seconds. X-axis tics are plotted every 10th day 
Amount of cold pixels (%)Fraction of pixels that deviate more than 8-sigma from mean value. Used exposure time was 42 seconds. X-axis tics are plotted every 10th day 
Temperature of the arrayMean temperature of the array during test. Minimum and maximum temperatures during the test are indicated by the error bar. X-axis tics are plotted every 10th day 
Dark current count dependency on exp timeRed points correspond to latest data Blue lines refer to 5 previous situations Number of counts per known exp time, 0s included 
|
|||||||||||||||||
|
